========================================================= Exabyte SCSI Tape Driver Installation Disk for Window NT 4.00 Version 2.10 COPYRIGHT (C) 1997-2000 BY Exabyte Corporation ========================================================= This Exabyte SCSI Tape Driver (Mammoth2.SYS) supports: - EXB-8500 series - EXB-8700 series - EXB-8900 series - Eliant - TR-4 - Mammoth2 tape drives. This driver fully supports the NT tape API. ------------------------------------------------------------------------------------------ INSTALLATION 1.) Boot the machine to Windows NT. 2.) Run "Tape Devices" in the "Control Panel" folder under the "Settings" start menu. 3.) If the "Tape Devices" application automaticaly attempts to install any drivers cancel their installation. 4.) Select the "drivers" tab in the "Tape Devices" window. 5.) Remove any previously installed Exabyte SCSI-2 tape drivers. 6.) Select "Add". 7.) Select "Have Disk". 8.) Enter the path to the OEMSETUP.INF files. 9.) When prompted to install the "Exabyte SCSI tape driver" tape drives," click OK. 10.) Reboot the system to activate the driver if asked by the application. ------------------------------------------------------------------------------------------ CHANGE LOG 1.00 - Initial Release. 1.10 - Add support for TAPE_ABSOLUTE... functions. 2.00 - Return correct values for tape capacity and tape remaining. 2.10 - Fix tape capacity and tape remaining values for TR4 scsi device. - Adjust timeout values for 'SmartClean' tapes. ------------------------------------------------------------------------------------------ IF THERE ARE PROBLEMS WITH THIS DISK Every effort was made to ensure the accuracy of this disk. Should you encounter a problem, please contact us at the following address: Exabyte Corporation 1683 38th Street Boulder, CO 80301 REMEMBER: Make a backup copy of this disk and put the original disk in a safe place!